FC595 Marble & Polished Stone Sealer – No Gloss

Solvent based impregnating sealer formulated to protect stone leaving a natural look. No gloss or color enhancement.

Recommended Surfaces

  • Marble & calcareous stone
  • All dense natural stone
  • Honed & polished finish
  • Grout joints
  • Floors, walls, counters & residential showers
  • Residential, commercial & institutional applications
  • Interior use & exterior use

Characteristics

  • Solvent – OMS (Odorless mineral spirit)
  • No color enhancement
  • No sheen
  • Doesn’t form a superficial film when dry
  • Protects against household dirt & stains
  • Provides water & oil repellent protection

Coverage

  • 946ml bottle (FC595-01)
  • 4L bottle (FC595-04)
  • 20L pail (FC595-20)

Environmental Data

  • VOC: 13gr / L

Remover

  • Solvent Based Sealer Remover (FC1350)

Maintenance

Commercial & Institutional

  • Neutral Floor Cleaner (FC300)

Residential

  • Vinyl, Tile & Stone Cleaner (FC110)
  • Granite Countertop Cleaner (FC313)

Packaging

  • 946ml bottle (FC595-01)
  • 4L bottle (FC595-04)
  • 20L pail (FC595-20)

Directions

Resealing Surface: Deep clean or remove any existing topical water based sealer using Heavy Duty Cleaner (FC350).

New Installation: Surface must be clean, dry and free of all foreign matter. Use the Pre-Finish Cleaner (FC250), Apply only after the grout manufacturer’s recommended curing time. Minimum 7 days.

Application

Using the FCS Mop (FC230) with the Application Cloth (FC225), or the White Scrub Pad (FC210) for smaller areas, apply a generous, even coat over the entire surface. Allow the sealer to sit on the surface for 10 to 15 minutes. Add more sealer or spread excess on the surface if needed. Afterwards, remove excess sealer with a dry cloth and let dry for 30 minutes.

To verify if Sealer Protection is Adequate: Put a few drops of water on the sealed surface and wait a few minutes. If the surface doesn’t darken, then the protection is adequate. Otherwise add another coat of sealer.

Caution & Limitations

  • Test product on small inconspicuous area
  • Protect adjacent areas against unexpected contact with product
  • Product should be used at room temperature
  • Regular reapplication schedule may be required on heavily used and high traffic areas

Cure Time

  • 72 hours for sealer to gain full strength
  • Light usage 3 hours
  • Cure time 72 hours