Urethane Hardwood & Laminate Finish – High Gloss FC260

Water-based urethane finish formulated to protect and rejuvenate hardwood, laminate & engineered wood floors leaving a high gloss finish

Recommended Surfaces

  • Varnished and also pre-varnished hardwood floors
  • Laminate floors
  • Parquet wood floors
  • Cork & bamboo floors
  • Engineered wood floors
  • Residential, commercial as well as institutional use
  • Interior use only

Characteristics

  • Water-based urethane finish
  • Gloss rating: >70
  • Protects against household dirt, staining and also abrasion
  • No ammonia
  • Low odor
  • Good leveling
  • Dries quickly
  • NMP & NPEO free

Coverage

  • 946ml covers approximately 20m² (200ft²)

Environmental Data

  • Low VOC: < 250gr / L
  • Biodegradable and is therefore in conformity with OCDE 301 E rule
  • Designed to meet the EcoLogo specifications

Remover

  • Heavy Duty Cleaner (FC350)

Maintenance

  • Hardwood Floor Cleaner (FC200)
  • Laminate Floor Cleaner (FC333)

Packaging

  • 946ml bottle (FC260-01)
  • 4L bottle (FC260-04)
  • 20L pail (FC260-20)

Urethane Hardwood Finish High Gloss Directions

Surface Preparation

Firstly deep clean floor and then remove existing floor finish or sealer with Heavy Duty Cleaner (FC350). When clean wash with clear water. If finish does not need to be removed, then use Pre-Finish Cleaner (FC250). Let dry completely before applying the finish.

Application

Using the FCS Mop (FC230) with the Application Mop Cloth (FC225), apply one coat evenly on the entire surface. Then allow 30 to 45 minutes for it to totally dry before applying another coat. Two coats are usually enough. No polishing required but it will enhance performance.

The process of applying this product is the same as in the following video:

Youtube channel here

Caution & Limitations

  • Test product on a small inconspicuous area
  • When applying the products protect adjacent areas against unexpected contact with the product
  • Product should be used at room temperature

Cure Time

  • Lightfoot traffic 12 hours
  • Normal circulation 3-5 days
  • Cure time 28 days

Disclaimer

N.B.  All above information is accurate. However, having no control over the conditions of utilization of the product, we cannot assume any responsibility, legal or other, in regards of the results and/or any prejudice from which derived.

Urethane Hardwood Floor Finish High Gloss MSDS

Back home