Urethane Hardwood & Laminate Finish – Satin Gloss FC280

Water-based urethane finish formulated to protect and rejuvenate hardwood, laminate and also engineered wood floors leaving a satin gloss finish.

Recommended Surfaces

    • Varnished as well as pre-varnished hardwood floors
    • Laminate floors
    • Parquet wood floors
    • Cork & Bamboo floors
    • Engineered wood floors
    • Residential, commercial and also Institutional use
  • Interior use only


  • Water-based urethane finish
  • Gloss rating: 30-35
  • Protects against household dirt, staining as well as abrasion
  • No ammonia
  • Low odor
  • Good leveling
  • Dries quickly
  • NMP & NPEO free


  • 946ml covers approximately 20m² (200ft²)

Environmental Data

  • Low VOC: <250gr /L
  • Biodegradable and therefore is in conformity with OCDE 301 E rule
  • Designed to meet the EcoLogo specifications


  • Heavy Duty Cleaner (FC350)


  • Hardwood Floor Cleaner (FC200)
  • Laminate Floor Cleaner (FC333)


  • 946ml bottle (FC280-01)
  • 4L bottle (FC280-04)
  • 20L pail (FC280-20)

Urethane Hardwood Finish Satin Gloss  Directions

Surface Preparation

Firstly deep clean floor and then remove existing finish or sealer with Heavy Duty cleaner (FC350). When clean wash with clear water. If finish does not need to be removed, then use Pre-Finish Cleaner (FC250). Let dry completely before applying the finish.


Using the FCS Mop (FC230) with the Application Mop Cloth (FC225),  apply one coat evenly on the entire surface. Allow 30 to 45 minutes to totally dry before applying another coat. Two coats are usually enough. No polishing required but will enhance performance.

The proccess of applying this product is the same as in this video:

Youtube channel here

Caution & Limitations

  • Test product on a small inconspicuous area
  • When applying the products protect adjacent areas against unexpected contact with the product
  • The product should be used at room temperature

Cure Time

  • Lightfoot traffic 12 hours
  • Normal circulation 3-5 days
  • Cure time 28 days


N.B.  All above information is accurate. However, having no control over the conditions of utilization of the product, we cannot assume any responsibility, legal or other, in regards of the results and/or any prejudice from which derived.

Urethane Hardwood Floor Finish Satin-Gloss MSDS

Back home