Urethane Laminate Finish Satin Gloss FC280

Urethane Laminate Finish Satin Gloss is a water-based urethane finish formulated to protect and rejuvenate hardwood, laminate & engineered wood floors leaving a satin gloss finish afterward.

Recommended Surfaces

    • Varnished as well as pre-varnished hardwood floors
    • Laminate floors
    • Parquet wood floors
    • Cork & Bamboo floors and also Engineered wood floors
    • Residential, commercial also Institutional use
  • Interior use only


  • Water-based urethane finish
  • Gloss rating: 30-35
  • Protects against household dirt, staining as well as abrasion
  • No ammonia
  • Low odor
  • Good leveling
  • Dries quickly
  • NMP & NPEO free


  • 946ml covers approximately 20m² (200ft²)

Environmental Data

  • Low VOC: <250gr /L
  • Biodegradable and also in conformity with OCDE 301 E rule
  • Designed to meet the Ecologo specifications


  • Heavy Duty Cleaner (FC350)


  • Hardwood Floor Cleaner (FC200)
  • Laminate Floor Cleaner (FC333)


  • 946ml bottle (FC280-01)
  • 4L bottle (FC280-04)
  • 20L pail (FC280-20)

Urethane Laminate Finish Satin Gloss Directions

Surface Preparation

First deep clean floor and remove existing finish or sealer with Heavy Duty cleaner (FC350). When clean wash with clear water. If finish does not need to be removed, then use Pre-Finish Cleaner (FC250). Let dry completely before applying the finish.


Using the FCS Mop (FC230) with the Application Mop Cloth (FC225),  apply one coat evenly on the entire surface. then allow 30 to 45 minutes for it to totally dry before applying another coat. Two coats are usually enough. No polishing required but will enhance performance.

The process of using this product is the same as in this video:

Youtube channel here

Caution & Limitations

  • Test product on a small inconspicuous area
  • When applying the product protect adjacent areas against unexpected contact with product
  • The product should be used at room temperature

Cure Time

  • Lightfoot traffic for 12 hours afterward
  • Normal circulation 3-5 days
  • Cure time 28 days


N.B.  All above information is accurate. However, having no control over the conditions of utilization of the product, we cannot assume any responsibility, legal or other, in regards of the results and/or any prejudice from which derived.

Urethane Laminate & Hardwood Floor Finish Satin-Gloss MSDS

Back home