Marble & Polished Stone Sealer No Gloss FC595

Marble & Polished Stone Sealer No Gloss is a solvent based impregnating sealer formulated to protect stone leaving a natural look afterward. No gloss or color enhancement.

Recommended Surfaces

  • Marble & calcareous stone
  • All dense natural stone
  • Honed & polished finish
  • Grout Joints
  • Floors, walls, counters  and also residential showers
  • Residential, commercial as well as in institutional applications
  • Interior use & exterior use

Characteristics

  • Solvent – OMS (Odorless mineral spirit)
  • No color enhancement
  • No sheen
  • Doesn’t form a superficial film when dry
  • Protects against household dirt as well as stains
  • Provides water & oil repellent protection

Coverage

  • 946ml bottle (FC595-01)
  • 4L bottle (FC595-04)
  • 20L pail (FC595-20)

Environmental Data

  • VOC: 13gr / L

Remover

  • Solvent Based Sealer Remover (FC1350)

Maintenance

Commercial & Institutional

  • Neutral Floor Cleaner (FC300)

Residential

  • Vinyl, Tile & Stone Cleaner (FC110)
  • Granite Countertop Cleaner (FC313)

Packaging

  • 946ml bottle (FC595-01)
  • 4L bottle (FC595-04)
  • 20L pail (FC595-20)

Marble & Polished Stone Sealer No Gloss Directions

Resealing Surface: First deep clean or remove any existing topical water-based sealer using Heavy Duty Cleaner (FC350).

New Installation: Surface must be clean, dry and free of all foreign matter. Use the Pre-Finish Cleaner (FC250), Apply only after the grout manufacturer’s recommended curing time. Minimum of 7 days afterward.

Marble & Polished Stone Sealer No Gloss Application

Using the FCS Mop (FC230) with the Application Cloth (FC225), or the White Scrub Pad (FC210) for smaller areas, apply a generous, even coat over the entire surface. Then allow the sealer to sit on the surface for 10 to 15 minutes. Add more sealer or spread excess on the surface if needed. Afterward, remove excess sealer with a dry cloth and then let it dry for 30 minutes.

To verify if Sealer Protection is Adequate: Put a few drops of water on the sealed surface and then wait a few minutes. If the surface doesn’t darken, then the protection is adequate. Otherwise, add another coat of sealer.

Caution & Limitations

  • Test product on a small inconspicuous area
  • While applying the product protect adjacent areas against unexpected contact with the product
  • The product should be used at room temperature
  • Regular reapplication schedule may be required on heavily used and high traffic areas

Cure Time

  • 72 hours for the sealer to gain full strength
  • Light usage for 3 hours afterward
  • Cure time 72 hours

Back home